Honda Prelude 1993 Service Manual page 554

J .
4.
Engage the parking brake pawl with the parking gear.
Cut the lock tabs of each shaft locknut using a chisel
as shown. Then remove the locknuts and conical
spring washers from esch shaft,
NOTE:
. Mainshaft locknut has left-hand threads.
. Clean the old locknuts; they are used to install the
press fit idler gears on the mianshaft and secondary
shaft and the parking gear on the countershaft.
. Always wear safety glasses,
CAUTION:
Keep all of ths chiselod particlos out ot tho
tranamission.
LOCK TAB
Rsmove the special tool from the mainshaft after
removing the locknuts.
Remove the parking gear using a puller f.om the
countershaft as shown. Then remove the idler gesrs
using a puller from the mainshaft and secondary shaft.
Remove the countershaft idler gear, needle besring.
thrust needle bearing. and thrust washer from the
countershaft.
Remove the parking brake pawl, spring, shaft. and
stopper from the housing.
Remove the throttle control lever and spring from the
throttle control shaft.
Remove the ATF cooler pipe mounting boh from the
transmission hanger.
Remove the transmission housing mounting botts.
o .
8.
9 .
1 0 .
1 1 .
SPRING PIl{
1 4- 93
12. Remove the reverse idler gear shaft holder.
NOTE;
The steel ball does not pop out becsuse it is stsked in
the shaft.
13. Move the reverse idler gear to disengage it trom the
countershaft and mainshsft reverse g€ars as shown.
NOTE:
The transmission housing will not separate from the
torque converter housing if the reverse idlsr gesr is
not removed.
MAINSHAFT
REVERSE IDLER GEAR
Move in this dirsction.
COUNTERSHAFT
14. Align the spring pin of the control shstt with the
transmission housing groove by turning the control
shaft.
15. Install the speci8l tool on the transmission housing,
then remove the housing as shown.
HOUSING PULLER
GROOVE
CONTROL SHAFT
,! o_ -:.-.:{>,
a \ ! r '
l l
i \