Honda Prelude 1993 Service Manual page 68

Engine Removal/lnstallation
MOUNT
h
! r
a Adiust the tension of the following drive belts:
Alternator belt (section 23).
Power steering pump belt (section 17).
Air conditioner compressor belt {section 22).
a Clean battery posts and cable tetminals with
sandpaper, assemble, then apply grease to pre-
vent corrosron.
Mount and Bracket Bolts/Nuts Torque Value Specifications:
TRANSMISSION MOUNT
a InsDect for fuel leakage.
After connecting all tuel line parts. turn on the
ignition switch (do not operate the starterl so
that the fuel pump operates for approximately
two seconds and the fuel line is pressurized.
Repeat this operation two or three times, then
check for fuel leakage at any point in the Juel
line.
(cont'd)
MOUNT
BRACKET
TRANSMISSION
1 0 r 1 . 2 5 m m
39 N.m 13.9 kg-m,
1 2 r 1 . 2 5 m m
95 N'm {9.5 kg-m, 69 lb-ftl
REAB MOUNT
'10 r '1.25 mm
39 N.m (3.9 kg-m,
28 lb-tt)
2a tb-ft|
1 2 x 1 . 2 5 m m
95 N.m (9.5 kg-rn, 69 lb-ftl
(Standard for
some tvpos)
'10 x 1.25 mrr
48 N.m (4.8 kg-m.
35 tb-ft|
SIDE ENGINE
MOUNTING BRACKET
I x 1 . 2 5 m m
22 N.m 12.2 kg-m, 16 lb-ftl
H23A'1. H22Al €ngine:
Et{GINE MOUNT
BRACKET A
l O x 1 . 2 5 m m
45 N.m {4.5 kg-m,
33 lb-tr)
8 x 1 . 2 5 m m
22 N.n 12.2 ks-m,
16 rb-ft|
lO x '1.25 mm
48 N.m (4.8 kg-m, 35 lb-ft)
5-28
FRONT MOUNT