Cam-Acl-Vlan - Dell Force10 S4810P Reference Manual

l2acl
ipv4acl
ipv6acl
ipv4qos
l2qos
l2pt
ipmacacl
ecfmacl
[vman-qos |
vman-dual-qos
number
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.1.0
Version 8.2.1.0
Version 7.8.1.0
Usage
You must save the new CAM settings to the startup-config (write-mem or copy run
Information
start) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and
these cannot be reallocated. The ipv4acl profile range is 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are 1 to 10, except for the ipv6acl profile which is 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

cam-acl-vlan

Specify the number of VFP blocks allocated to OpenFlow.
S4810
Syntax cam-acl-vlan vlanopenflow {0|1} vlaniscsi {0|1}
Defaults Disabled.
Parameters
vlanopenflow
vlaniscsi
108
number
Allocate space to each CAM region.
number
Enter the CAM profile name followed by the amount of CAM space to
number ,
be allotted. The total space allocated must equal 13. The ipv6acl
number
range must be a factor of 2.
number ,
number
number
number
Introduced on the Z9000.
Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the number 1 to allocate VFP blocks and enable OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
Enter the number 1 to allocate VFP blocks for iSCSI.
Enter the number 0 to disable iSCSI CAM allocation.