Cam-Acl-Vlan - Dell Z9500 Reference Manual

cam-acl-vlan

Configure the number of flow processor (FP) blocks of CAM allocated to ACL VLAN services on the
switch.
Syntax
cam-acl-vlan {default | vlanopenflow <0-2> | vlaniscsi <0-2> |
vlanaclopt <0-2>}
Parameters
default
vlanopenflow
<0-2>
vlaniscsi <0-2>
vlanaclopt
<0-2>
Default To reset the number FP blocks allocated for ACL VLAN processes, enter the
default keyword with the cam-acl-vlan command. By default, 0 FP blocks are
allocated for ACL VLAN operations on the switch.
Command ACL-VLAN-GROUP CONFIGURATION
Modes
Command
Version
History
9.5(0.1)
9.3(0.0)
Usage The VLAN ContentAware Processor (VCAP) application is a pre-ingress CAP that
Information modifies the VLAN settings before packets are forwarded. To support the ACL CAM
optimization functionality, the CAM carving feature is enhanced. A total of four
VACP groups are present, of which two are for fixed groups and the other two are
for dynamic groups. Out of the total of two dynamic groups, you can allocate zero,
one, or two flow processor (FP) blocks to iSCSI counters, Open Flow and ACL
VLAN optimization. You can configure CAM FP blocks for only two of these ACL
VLAN services at a time.
Access Control Lists (ACL)
Reset the number of FP blocks to the default value. By
default, 0 FP blocks of CAM are allocated for ACL VLAN
services, such as iSCSI counters, Open Flow, and ACL VLAN
optimization.
NOTE: CAM optimization for ACL VLAN groups is not
enabled by default. You must allocate FP blocks of ACL
VLAN CAM to enable ACL CAM optimization.
Allocate a number FP blocks of CAM for VLAN Open Flow
operations.
Allocate a number FP blocks of CAM for VLAN iSCSI
counters.
Allocate a number of FP blocks of CAM for CAM optimization
of ACL VLAN operation.
Description
Introduced on the Z9500.
Introduced on the S4810 and Z9000.
253