Arp Backoff-Time - Dell Z9500 Command Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.2.1.0
Usage You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when
Information creating a static ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid.
Related
clear arp-cache
Commands
show arp

arp backoff-time

Set the exponential timer for resending unresolved ARPs.
Z9500
Syntax
arp backoff-time seconds
Parameters
seconds
Defaults 30
Command CONFIGURATION
Mode
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
IPv4 Routing
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— clears dynamic ARP entries from the ARP table.
— displays the ARP table.
Enter the number of seconds an ARP entry is black-holed.
The range is from 1 to 3600. The default is 30.
Description
Introduced on the Z9500.
925