Show Multicast Usage - Dell PowerConnect J-EX4200-24T Software Manual

show multicast usage

Syntax
Syntax (J-EX Series
Switch)
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Chapter 80: Operational Mode Commands for IGMP Snooping and Multicast
show multicast usage
<brief | detail>
<inet | inet6>
<instance instance-name>
<logical-system (all | logical-system-name)>
show multicast usage
<brief | detail>
<inet | inet6>
<instance instance-name>
Command introduced before Junos OS Release 10.2 for J-EX Series switches.
Display usage information about the 10 most active Distance Vector Multicast Routing
Protocol (DVMRP) or Protocol Independent Multicast (PIM) groups.
none —Display multicast usage information for all supported address families for all
routing instances.
—(Optional) Display the specified level of output.
brief | detail
inet | inet6 —(Optional) Display usage information for IPv4 or IPv6 family addresses,
respectively.
instance instance-name —(Optional) Display information about the most active DVMRP
or PIM groups for a specific multicast instance.
logical-system (all | logical-system-name)
systems or on a particular logical system.
view
show multicast usage on page 2212
show multicast usage brief on page 2212
show multicast usage instance on page 2212
show multicast usage detail on page 2212
Table 280 on page 2211 describes the output fields for the
Output fields are listed in the approximate order in which they appear.
Table 280: show multicast usage Output Fields
Field Name Field Description
Name of the routing instance. (Displayed when multicast is configured within
Instance
a routing instance.)
Group address.
Group
—(Optional) Perform this operation on all logical
show multicast usage command.
2211