Related to Command Processing
Setting the Command (COMMAND)
There are 2 types of commands, the GP-GL and the HP-GL, that the plotter can use. Match the setting to the
used software, or set it to AUTO.
Automatic detection of the command may make mistake depending on the data. It will give error or malfunction when it has made mistake. In
that case, set the command before using.
Always send the data when the plotter is in READY status when in the automatic detection of the command.
Once the data is cut with the automatic detection of the command, it will be ready to automatically detect next command 10 seconds after
completing the cutting. Send next data after 10 seconds has past after previous cutting when sending data with different command.
Press the [MENU] key in the default screen.
MENU screen is displayed.
Press the POSITION (¡ã ) key (I/F).
INTERFACEsetting screen (1/3) is displayed.
Press the  key (COMMAND).
COMMAND setting screen is displayed.
Select the  key (GP-GL), the  key (HP-GL), or the  key
Confrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to INTERFACEsetting screen (1/3).
Press the [MENU] key.
It will return to the default screen.