Names Of The Main Parts; Plotter Nomenclature - GRAPHTEC FC 4500 Series Service Manual

2

NAMES OF THE MAIN PARTS

2.1

Plotter Nomenclature

FC4500-50 / FC4500-60
(1) Tool carriage
(2) Tool holder
(3) Pen station
(4) Y bar
(5) Writing panel
(6) Control panel
(7) USB interface connector
(8) RS-232C interface connector : Used to connect the plotter to a computer via the RS-232C interface.
(9) AC line inlet
(10) Power switch
(11) CHART HOLD key
7
8
9
10
FC4500-UM-251-9370
: Drives the cutter pen/pen/creasing tool to the forward/backward.
: Holds the cutter pen/pen/creasing tool and drives it up/down.
: Holds a pen.
: Holds the tool carriage; moves left/right.
: Cutting/plotting is performed here.
: Used to set and use the plotter's various functions.
: Used to connect the plotter to a computer via the USB interface.
: Connect one end of the power cord here and the other end to an
electrical socket.
: Controls the on/off status of the power supply to the plotter.
: Used to hold the medium. (FC4500–50 only)
FC4500-50/60
1
2
3
12
6 11
5
2 NAMES OF THE MAIN PARTS
5
4
Tool holder 1
Tool holder 2
Pen station
7
8
9
10
1
2
6