Nomenclature; Front View - GRAPHTEC FC9000 Series User Manual

1.2

Nomenclature

Front view

This section explains in the FC9000-140.
Cutting mat
Grit rollers
Power switch
Power switch ...........................Used to turn the plotter on and off.
Control panel ...........................Used to access various plotter functions.
Push rollers .............................Rollers that push the media against the grit rollers.
Grit rollers ...............................Feeds the media back and forth.
Media sensors ........................The front sensor is used to sense the leading edge of the media. The rear
Tool carriage ...........................Moves the cutter-pen or plotting pen across the media during cutting or
Tool holder ..............................Holds the cutter-pen or plotting pen and moves it up or down.
Grit roller position guide .......
Cutting mat .............................The cutter blade moves on this cutting mat.
Cutting groove ........................Use this groove to cut out (die cut) or cross cut.
Media set lever .......................Used to raise or lower the Push rollers during the loading or unloading of
Media stopper .........................
Grit roller position guide
Cutting groove
Cross cut unit
Push rollers
sensor is used to sense the trailing edge of the media.
plotting.
position of each grit roller. Use these alignment marks as an aid in locating the
Push rollers.
media.
when pulling roll media straight out.
Tool carriage Tool holder
Pen holder
Media sensors
1-4
Pen station
Control panel
Media set lever
Media stopper