Nomenclature; Front View - GRAPHTEC CE6000-120AP User Manual

1.2

Nomenclature

Front View

Grit roller position guide
Marking mat
Cutting groove
Grit roller
Media flange
Stock shaft
Control panel ...........................Used to access various plotter functions.
Push rollers .............................Rollers that push the media against the grit rollers.
Grit rollers ................................Metallic rollers with a file-like surface that feed the media back and forth.
Media sensors .........................The front sensor is used to sense the leading edge of the media. The rear
Tool carriage ............................Moves the cutter-pen or plotting pen across the media during cutting or
Cutter holder ...........................Holds the cutter in position while moving up and down.
Pen holder ................................Holds the pen in position while moving up and down.
Pen station ...............................Fixes the pen in position before use.
Grit roller position guide ........Stickers on the front of the Y rail and the rear side of the top cover that show
Marking mat .............................The oil-base ballpoint moves above this and does the cutting/plotting.
Cutting groove .........................Use this groove when using the media cutter.
Media set lever ........................Used to raise or lower the Push rollers during the loading or unloading of
Tool carriage
Cutter holder
Media guide
Push roller
Media stopper
sensor is used to sense the trailing edge of the media.
plotting.
the position of each grit roller. Use these alignment marks as an aid in locating
the Push rollers.
media.
1-3
Pen holder
Media set lever
Control panel
Media sensor
RS-232C interface connector
Pen station
USB interface connector