Automatically Cross-Cut - GRAPHTEC FC9000 Series User Manual

Cutting plotter

Hide thumbs Also See for FC9000 Series:

Table of Contents

Automatically cross-cut

When plotting with the supplied software, you can cross-cut automatically after plotting is completed. For details,

see the manual of the supplied software.

When Apparel (AP) mode setting is set to Enabled, Cross Cut is performed with timeout and separator command

without receiving cross cut command. The position to cross-cut is the position separated from the plotted range by

"SPACE REAR".

For "Margin behind" and "Apparel (AP) mode" see "Apparel (AP) mode".

Fc9000-75 Fc9000-100 Fc9000-140 Fc9000-160