Automatically Adjust - GRAPHTEC FC8000 Series User Manual

Set the shape and size of the registration mark, mark distance,
3
distance adjust mode, offset, paper-weight, sensor level, scan
position adjustment, etc., as needed.
Setting Shape (Pattern) of Registration Mark
P .5-9
Setting Registration Mark Size
P .5-11
Setting Mark Distance
P .5-12
P .5-14 Setting Distance Adjustment Between the Registration Mark
P .5-16 Setting Offset Between the Registration Mark and Cutting Origin Points
P .5-18 Adjusting the Sensor Level
P .5-19 Manually Adjusting the Sensor Level (Threshold Value)
Setting Paper-Weight
P .7-21
Press the [MENU] key.
4
MENU screen is displayed.
Press the [2] key (ARMS).
5
ARMS SETTINGscreen is displayed.
Steps are different from here depending if it is going to move to
registration mark automatically to scan the registration mark, or
if it is going to move manually to scan. See next section.

Automatically Adjust

P .5-34
Adjust Manually
P .5-36
Automatically Adjust
This section describes the operation to adjust with registration
mark scan by moving to registration mark automatically after
setting the ARMS mode and POINTS.
Operation
Press the [1] key (AUTO READ MARKS) in the ARMS setting
1
screen (1/4).
Following message is displayed.
Next page
Supplement
It is not necessary to set the MARK DISTANCE
when it is adjusted manually.
Supplement
See "Adjust Manually"
moving manually to registration mark for scanning.
Supplement
Press the [2] key (ARMS) in the MENU screen if it
is not ARMS setting screen.
5-34
P .5-36 if you are