Running Cutting Tests; Cutting Test; To Make 1 Cut With Set Value - GRAPHTEC FC9000 Series User Manual

2.11

Running Cutting Tests

Test cutting can be performed after making the tool, speed, force, and acceleration settings to ensure that the
selected cutting conditions actually produce the desired cutting results. Check how far the blade cuts into the
repeat the test cutting until the optimal settings are achieved.

Cutting test

Here, you can either cut one test pattern based on the current values, or do three tests with ±1 values added.

To make 1 cut with set value

Operation
1
Load the media for test cutting in the plotter.
2
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
3
Press the POSITION ( ) key (CUT TEST).
4
Press the POSITION (
to the location you wish to perform the test cutting.
5
Press the [ENTER] key.
1 cut test pattern is cut.
6
Press the [ENTER] key after completion.
CONDITION setting screen is displayed.
7
Press the [COND/TEST] key.
It will return to default screen.
) keys to move the tool carriage
2-43
Supplement
It will return to CONDITION setting screen when
you press the [ESC] key (CANCEL).
Supplement
Pressing the POSITION and [SLOW] keys at the
same time will move the tool carriage slower.
CAUTION
When the [ENTER] key is pressed, the tool
carriage will start moving, so take care not to get