Setting The Registration-Mark Mode - GRAPHTEC CE5000-60 User Manual

■ Setting the Registration-Mark Mode

M A R K M O D E
M A R K P O S I T I O N
M A R K T Y P E
M A R K S I Z E
M A R K D I S T . A D J .
M A R K O F F S E T
M A R K S E N S O R A D J 1
M A R K S E N S O R A D J 2
M A R K A U T O S C A N
M A R K S E N S O R A D J
For 2-point alignment, the origin and X-axis registration marks are read; for 3-point
alignment, the origin, X-axis, and Y-axis registration marks are read; and for 4-point
alignment, all four registration marks are read. Axis alignment (correction of any
tilt) and distance adjustment are then performed.
Registration-mark pattern 1
Point 4
Point 3
1
Step
Press the (PAUSE) key to switch to PAUSE mode.
2
Step
Press the (NEXT) or
A U T O R E G . M A R K
3
Step
Press the (ENTER) key to display the Auto Reg. Mark submenu.
M A R K M O D E
4
Step
Press the (ENTER) key to display the MARK mode settings.
M A R K M O D E
5
Step
Press the or key to select "OFF," "2 POINT," "3 POINT," or "4 POINT," and
then press the (ENTER) key to confirm.
6
Step
Press the (PAUSE) key to cancel PAUSE mode.
Point 4
Point 2
Point 1
(Drawing
origin point)
Move the cutter blade
within this area.
(PREV.) key until the following menu is displayed.
O F F
4 – 11
Registration-mark pattern 2
Point 2
Move the cutter
blade within
this area.
Point 3
Point 1
(Drawing
origin point)
X
Y