Example 3: Create An Auto Voip Vlan - NETGEAR M4200 Software Administration Manual

Example 3: Create an Auto VoIP VLAN

This example is provided as CLI commands and as a web interface procedure.
CLI: Create an Auto VoIP VLAN
Since no default VoIP VLAN is specified, you must create a VLAN first to use auto VoIP.
1. Create VLAN 5.
(Netgear Switch) #vlan database
(Netgear Switch) (Vlan)#vlan 5
(Netgear Switch) (Vlan)#exit
2. Assign the VoIP traffic to VLAN 5, which becomes the VoIP VLAN.
(Netgear Switch) (Config)#auto-voip vlan 5
3. Display the protocol-based Auto VoIP information.
(Netgear Switch) #show auto-voip protocol-based interface 2/0/1
VoIP VLAN Id................................... 5
Prioritization Type............................ traffic-class
Class Value.................................... 6
Interface Auto VoIP Mode Operational Status
--------- -------------- -----------------
2/0/1 Enabled
4. Display the OUI-based Auto VoIP information.
(Netgear Switch) #show auto-voip oui-based interface 2/0/1
VoIP VLAN Id................................... 5
Priority....................................... 7
Interface Auto VoIP Mode Operational Status
--------- -------------- ------------------
2/0/1 Disabled
Managed Switches
Up
Down
DiffServ
259