Interface Board (Cd-Rw/Tandem Copy Kit/Printer Controller); Installation Procedure - Gestetner A294 Service Manual

INTERFACE BOARD
(CD-RW/TANDEM COPY KIT/PRINTER CONTROLLER)
3.8 INTERFACE BOARD
(CD-RW/TANDEM COPY KIT/PRINTER CONTROLLER)

3.8.1 INSTALLATION PROCEDURE

The interface control board is needed to use the optional CD-ROM writer (CD-RW),
optional printer controller, or the tandem copy kit.
[B]
B327I101.WMF
B327I103.WMF
1. Remove the upper rear cover of the copier.
2. Remove the fly wheel [A] (3 screws) and the drum cooling fan [B].
3. Install the support bracket [C] (2 screws) on the interface board [D].
⇒
NOTE: When the CD-RW is installed, remove the short connector [E]
installed on TB101.
4. Connect the interface board to the connector on the SICU. Then secure the
support bracket to the copier (2 screws).
5. Connect the cable of the optional equipment to the terminal of the interface
board.
1) When the CD-RW is installed, connect the cable from the CD-RW to the
connector [a] and route the cable as shown. Secure the cable with the upper
clamp.
2) When the cable for the tandem copy kit is installed, connect the cable to the
connector [b] and route the cable as shown. Secure the cable with the lower
clamp.
NOTE: The connector [c] is for the printer controller.
SM
CÓPIA NÃO CONTROLADA
[A]
[b]
[E]
[c]
3-31
CÓPIA NÃO CONTROLADA
Rev. 6/2000
[C]
[a]
[D]
B327I102.WMF
A294/A295