Hard Disk Drive - Gestetner A294 Service Manual

Rev. 02/2000

6.12.2 HARD DISK DRIVE

1. Remove the upper right cover (4 screws). See Exterior.
2. Remove three screws [A] holding the HDD bracket [B]. Then pull out the HDD
assembly.
3. Replace hard disk drive 1 [C] or hard disk drive 2 [D] (2 screws and 2
connectors each).
NOTE: Connect the black connector to HDD 1, and the gray connector to HDD
2.
4. Turn the main switch on and do SP4-911-6 (for HDD 1) or SP4-912-6 (for HDD
2).
NOTE: If either SP4-911-1 or SP4-912-1 is done, all the data for pre-set
stamps and user stamps are deleted from both disks.
5. Install the stamp data using a flash memory card. (Refer to Stamp Data
Installation in section 4.)
SM
CÓPIA NÃO CONTROLADA
[A]
[C]
6-111
CÓPIA NÃO CONTROLADA
BOARDS AND OTHER ITEMS
[D]
[A]
[B]
[A]
A294R943.WMF
A294/A295