Card Cage/Back Plane Remove And Replace; Card Cage/Back Plane Removal - Overland Storage Neo Series Library Service Manual

Card Cage/Back Plane Remove and Replace

NOTE: The Card Cage/Back Plane assembly is located on the right side at the rear of the library.
The Library Controller Card and the Drive 1 Shoe Assembly must be removed to remove the Card
Cage/Back Plane assembly.

Card Cage/Back Plane Removal

1) If the library is operational, remove any cartridges in the drives using the Graphical User
Interface (GUI) or application software.
2) Exit the application software and halt the operating system if necessary.
3) Power off the library using the GUI and then switch the Master Power Switch on the power
supply at the rear of the module to the off (0) position. Remove the power cord.
4) Remove the FCO Card, if installed, using
instructions in this chapter.
5) Remove the Library Controller Card using
instructions in this chapter.
6) Remove the Drive 1 Shoe Assembly using
instructions in this chapter.
7) Remove the tabletop cover and Fan Cover Assembly using
Replace" using instructions in this chapter.
8) Remove the screw from the Card Cage/Back Plane Connector Access Plate and lift it out of
the library. See Figure
9) Remove the Drive 1 drive guide using
this chapter.
10) From outside the chassis, remove two flat-head screws at the top of the card cage and two flat-
head through-bolts at the bottom of the card cage.
"Fibre Channel Option Card Remove and Replace"
"Library Controller Card Remove and Replace"
"Drive Shoe Assembly Remove and Replace"
2–39.
"Drive Guides Remove and Replace"
C C /B P R
ARD AGE ACK LANE EMOVE AND
"Library Covers Remove and
instructions in
Servicing the Neo Series 2000
R
EPLACE
2-41
t