Appendix B
Alignment Procedure
This procedure is performed when vertical axis components are removed or replaced. The
procedure is performed by entering commands via the Graphical User Interface (GUI).
1) Remove the four magazines from the library
NOTE: Removing the magazines speeds up initialization by eliminating the need to perform
a full library inventory.
2) Turn on the library module as follows:
a. Connect the power cords to the power supply's receptacle (1).
b. Toggle the power switches located on the power supply to ON (2).
c. Press anywhere on the GUI touch screen to apply power to the module (3).
3) Press "Menu" from the initialization screen,
Vertical Axis Alignment
2
1
Figure B–1. Applying Power
3
Figure
B–2.
B-1
t