Shuttle Assembly Track Sensor Remove And Replace; Shuttle Assembly Track Sensor Removal - Overland Storage Neo Series Library Service Manual

P/n 104241-xxx
Table of Contents

Advertisement

S
A
T
S
HUTTLE
SSEMBLY
RACK
ENSOR

Shuttle Assembly Track Sensor Remove and Replace

The Shuttle Assembly Robot Track Sensor is located in the chassis bottom beneath the point where the
rotating track section meets the stationary track section. The stationary track section and the Drive 1
Shoe Assembly must be removed to remove the Shuttle Assembly Track Sensor.

Shuttle Assembly Track Sensor Removal

2-54
Servicing the Neo Series 2000
u
R
R
EMOVE AND
EPLACE
1) Remove both magazines from the library using the front panel control. Refer to the section
"Emergency Magazine Removal"
2) Power off the library using the Graphical User Interface (GUI) and switch the Master Power
Switch on the power supply at the rear of the module to the off (0) position.
3) Remove the power cord from the receptacle.
4) Remove the tabletop cover, Fan Cover Assembly and front main cover using
Remove and Replace"
5) Remove the screw from the Card Cage/Back Plane Connector Access Plate and lift it out of
the library, see
Figure
6) Remove the drive 1 shoe assembly using
instructions in this chapter.
7) Move the Shuttle Assembly to the front of the library by releasing the brake and pushing it at
the base near the track. If necessary, refer to
Service or Shipment"
8) Operate the worm gear drive link for the rotating track section and turn it perpendicular to
stationary track, see
9) Remove the two screws that mount the Track Sensor to the studs on the track base. See
Figure
2–53.
if necessary.
instructions in this chapter.
2–39.
"Drive Shoe Assembly Remove and Replace"
"Parking the Shuttle Assembly Robotics for
instructions in this chapter.
Figure
2–53.
"Library Covers

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Neo Series Library and is the answer not in the manual?

This manual is also suitable for:

Neo series 2000Neo series 4000

Table of Contents