M
S
ENU
ELECTIONS
4-16
Operation
u
Table 4-2 View Library Options (Continued)
Option
Unload Mode
Selects the unload mode for library tape drives. If Implicit, the
library unloads a tape drive before attempting to move a cartridge
from that tape drive. If Explicit, the host must issue a SCSI
UNLOAD command to a tape drive before each MOVE MEDIUM
command that removes a cartridge from that tape drive. The
default is Implicit.
Total Reserved Slots
Lets you remove from use a specified number of slots at the rear
of the magazine. Some host software imposes size limits on
library magazines for licensing purposes, and does not operate
with a library that exceeds the licensed size. The default is 0.
Auto Clean Mode
Lets you enable an automatic cleaning cycle. To use this option,
you must have reserved a slot for a cleaning cartridge using the
Total Reserved Slots option. The default is Disabled.
Drive and Slot
Lets you specify whether SCSI elements in the library displays
Numbering
with either zero-based or one-based. This only affects the GUI
touch screen, not the actual SCSI element addresses. The default
is one based.
Library Mode
Lets you set the robotics operating mode to Random or Sequential
The default is Random.
Sequential Mode
Lets you select a normal or recirculate frequency mode. The
default is Normal. (*Only available if Library Mode is set to
Sequential)
LCD Contrast Adjust
The LCD contrast controls let you increase or decrease the
contrast of the LCD display. The incremental steps are set by
adjusting the LCD Contrast Adjust option from the Library option.
Incremental steps can range from 0 to 31 depending on your
preference.
Mail Slot Mode
Lets you enable the mail slots in a library. The default is Mail Slot
Enabled (Neo Series 2000), or Both Mail Slots Enabled (Neo Series
4000).
Barcode Label Size
Lets you limit the maximum number of characters of the bar code
label. Possible settings are 1 through 8. The default is 8.
Barcode Label
Lets you specify the alignment of a bar code label. The options are
Alignment
Left or Right. When used in conjunction with the label size option,
this option strips unwanted trailing characters (left alignment) or
leading characters (right alignment). The default is Left Align.
Barcode Label Check
Lets you specify whether to enable or disable the verification of a
Digit
check digit character in the barcode label. The default is Disabled.
Barcode Reader
Lets you specify whether the barcode reader will retry reading
barcode labels. The default is Retries Enabled.
Description
Need help?
Do you have a question about the Neo Series Library and is the answer not in the manual?