Power Supply Receiver Remove And Replace; Power Supply Receiver Removal - Overland Storage Neo Series Library Service Manual

Power Supply Receiver Remove and Replace

The Power Supply Receiver is installed on the left side at the rear of the library and houses the quick-
change power supply and the power cord receptacle. The Power Supplies, Drives 2 and 4 (or the blank
covers), and the Elevator Assembly (or blank cover), must be removed to replace the Power Supply
Receiver.

Power Supply Receiver Removal

1) Access and Remove the right magazines using the Graphical User Interface (GUI). Refer to
the section "Emergency Magazine Removal"
2) Power off the library using the GUI and then switch the Master Power Switch on both power
supplies at the rear of the module to the off (0) position.
3) Remove the power cords from the receptacles.
4) Remove the Power Supplies using applicable steps in the
Replace" instructions in this chapter.
5) Remove the Tabletop Cover, Front Chassis Cover and Power Supply Receiver Cover using
"Library Covers Remove and Replace"
6) Remove Drives two and four using procedures in
Replace".
NOTE: Allows access to side of the Elevator Assembly or Blank cover mounting screws.
7) Remove the five screws (three outer and two inner) connecting the Elevator Assembly or
Blank Cover to the chassis.
NOTE: For multiple module systems with the Elevator Assembly installed, the entire Elevator
Assembly must be removed. Refer to the Neo Series Elevator Assembly Installation Instruction
P/N 104252-XXX.
8) Working through the opening behind the right magazine track, remove the two 22-pin main
power harness connectors.
9) Remove the four 4-pin drive power connectors,
10) At the back of the library, remove the five mounting screws while supporting the receiver.
11) Carefully remove the receiver through the opening in the top of the library.
P S R
OWER UPPLY ECEIVER
if necessary.
"Power Supply Remove and
instructions in this chapter.
"Drive Shoe Assembly Remove and
(Figure 3–37).
Servicing the Neo Series 4000
R R
EMOVE AND EPLACE
3-39
t