Control Panel Pcb Remove And Replace; Control Panel Pcb Removal; Control Panel Pcb Replacement; Figure 2-25 Control Panel Pcb Remove And Replace - Overland Storage Neo Series Library Service Manual

C P PCB R
ONTROL ANEL EMOVE AND

Control Panel PCB Remove and Replace

The Control Panel Printed Circuit Board (PCB) is mounted in the bottom of the library chassis
immediately behind the Front Panel.

Control Panel PCB Removal

Control Panel PCB Replacement

2-26 Servicing the Neo Series 2000
u
R
EPLACE
1) Using the GUI, open the left magazine door and remove the magazine. If the module is not
operable, refer to "Emergency Magazine
2) Using the front panel control, park the cartridge Shuttle Assembly by powering off the module
and then switch the Master Power Switch on the power supply at the rear of the module to the
off (0) position. If the module is not operable, refer to
for Service or Shipment".
3) Remove the power cord from the receptacle.
4) Remove the tabletop cover and front main cover using
instructions in this chapter.
5) Disconnect the cables at J12, J10, J1, J9, J14, J16, J13 and J3. Disconnect the zero insertion
force cable at J15 by sliding up the body of the connector to release the flex cable. Remove the
flex cable from the connector, see
J12
J10
J15
J16
J14
J13
Figure 2–25. Control Panel PCB Remove and Replace
6) Remove the three screws mounting the PCB to the chassis.
7) Lift the Control Panel PCB from the Chassis.
1) Position the Control Panel PCB over the mounting studs in the bottom of the chassis with
connector J1 towards the rear of the library.
2) Install the three screws that mount the PCB to the chassis, see
3) Connect the cables at J12, J10, J1, J9, see
Removal".
Figure 2–25.
J1
J9 J3
Figure
"Parking the Shuttle Assembly Robotics
"Library Covers Remove and Replace"
Neo-9048
Figure 2–25.
2–25.