Drive Divider Remove And Replace; Drive Divider Removal - Overland Storage Neo Series Library Service Manual

D D R R
RIVE IVIDER EMOVE AND EPLACE

Drive Divider Remove and Replace

The Drive Dividers are installed between the Drive 1 and Drive 2 and Drive 3 and Drive 4 shoe
assemblies.

Drive Divider Removal

3-62 Servicing the Neo Series 4000
u
NOTE: The Drive Shoe assemblies must be removed prior to removing the Drive Divider.
1) If the library is operational, remove any tape cartridges in the tape drives using the Graphical
User Interface (GUI) or application software.
2) If necessary, exit the application software and halt the operating system.
3) Using the GUI touch screen, power off the library. Toggle the power switches on the power
supplies at the rear of the module to the OFF (0) position and then remove the AC power
cords.
4) Remove the applicable Drive Shoe assemblies following the instructions in
Assembly Remove and
5) Remove two flat-head screws that secure the Drive Divider to the library chassis (see
Figure 3–58).
6) Remove the 2 screws from the lower outside Card Cage/Back Plane Connector Access Plate
remove it from the library.
7) Inside the chassis between the upper and lower drive bays (on early model modules, current
models have been modified to expose the screw), remove the 2 screws that secure the power
cable wire harness cover plate
NOTE: Permits access to the lower Drive Divider inner mounting screw.
Replace".
(Figure 3–57).
"Drive Shoe