Overland Storage Neo Series Library Service Manual page 245

Table 5-2 Fault Symptom Codes (Continued)
Message
Cart Unaccessible
Drive In Error
No Magazine
Removal Prevented
Ctl. Firmware Error
Drive Timeout Error
Drive Code Update Command Error
Move Command Failure
Open Mail Slot Fault
Open Left Door Fault
Open Right Door Fault
Open Doors Fault
Open DLT Handle Fault
No IP Address Found
No IP Address Mode Fault
Unknown exchange for the async
message
Drive In Error
Drive In Error
Drive In Error
Drive In Error
Motor Fault Condition
Picker Tach Errors
FSC ERP
200C F For a DLT drive, fail to operate drive
handle in unloaded state. For a SDLT,
indicates the tape is NOT in the unloaded
state. For a SLTO, indicates the tape is not
ejected. Cartridge in drive is not
accessible from changer.
200D C,G A general drive error detected by control
task.
200E F Cannot move, element not installed , from
changer.
200F F Receive medium prevent removal from
drive for a fetch.
2010 C,G Internal inter task processing error.
Unexpected event. SMX send or receive
error.
2030 C,G Can't communicate with DLT drive.
2080 C,G Update code from SCSI or from TAPE
failed.
2081 C,G Move command from / to drive slot failed,
detected by control task.
2090 C,G Door open sensor timeout detected when
open door.
2091 C,G Door open sensor timeout detected when
open door.
2092 C,G Door open sensor timeout detected when
open door.
2093 Door open sensor timeout detected when
open door.
2094 C,G Failed to open DLT handle.
20a0 C,G SMC router fialed to get an IP address.
20a1 C,G SMC router failed to detected static or ip
address Mode.
20b0 C,G Unexpected exchange detected when
process Messages.
20c0 C,G Cotronl failed to set SCSI id.
20c1 C,G Control failed to installed drive.
20c0 C,G Cotronl failed to set SCSI id.
20c1 C,G Control failed to installed drive.
3000 C,G One of the motors has been disabled and
could not be re-enabled.
3002 C,G Picker Tach errors were detected when
checking slots.
F S C (FSC )
AULT YMPTOM ODES S
Troubleshooting 5-5
t