Neo Series Module Configuration; Configuring Modules For Elevator Application; Configuring The Primary Master Module; Figure C-20 Powering Up The Library - Overland Storage Neo Series Library Service Manual

N S M C
EO ERIES ODULE ONFIGURATION

Neo Series Module Configuration

Configuring the multi-module Neo library identifies which Library module is the Master and which are
the Slaves. The module designated as the Primary Master has the ability to monitor, view and modify
parameters and settings of the entire multi-module Library. It is readily apparent by comparing the
Primary Master and Slave Graphical User Interfaces (GUI). The Primary Master can be used to perform
many of the common functions within each slave module. The following procedure prepares your multi-
module library for Elevator use.

Configuring Modules For Elevator Application

If the modules are not powered up, apply power to all library modules as follows, see

Configuring the Primary Master Module

C-20
u
NOTE: The following procedure assumes that the modules are configured for standalone
operation, have been rack mounted, the system router is installed at the top of the rack
above the Primary Master with power off and the 10BaseT cabling is not connected to
any of the modules.
2
1
Figure C–20. Powering up the Library
1. Connect the power cord to the power supply's receptacle (1).
b. Toggle the power switch located on the power supply to ON (2).
c. Press anywhere on the GUI touch screen to apply power to the module (3).
1) On the GUI at the Neo module located at the top of the rack (to be identified as the Primary
Master) Press Menu.
Figure
3
Neo-9127
C–20: