Elevator Assembly Extension; Elevator Assembly Required Tools - Overland Storage Neo Series Library Service Manual

Elevator Assembly Extension

Mechanical Installation
Assembly of the Neo Series Elevator Assembly requires experience working with moderately complex
mechanisms, and the ability to follow directions carefully.
The Elevator Assembly is made up of the following components as shown in
•
Elevator Primary Chassis (10U or 20U lengths)
•
Elevator Media Car
•
Elevator PCB
•
Belt Block and Brackets
•
Drive Belt
•
Drive Motor
•
Drive Motor Pulley
•
Belt Tensioning Ramp and Idler Pulley
•
Standoff
•
Motor Cable
Elevator Extension Components
•
5U, 10U, or 20U Extensions
•
Tie Bars (to connect extensions)
•
Install Hardware

Elevator Assembly Required Tools

•
#2 Phillips, Stubby, or right-angle screwdriver
•
Flat-blade screwdriver
•
0.050-inch Allen wrench (recommended)
•
Scissors or knife (for sizing the belt)
E A E
LEVATOR SSEMBLY XTENSION
Figure C–8.
C-11
t