Card Cage/Back Plane Remove And Replace; Card Cage/Back Plane Removal - Overland Storage Neo Series Library Service Manual

Card Cage/Back Plane Remove and Replace

The Card Cage/Back Plane assembly is located on the top right side at the rear of the library. The Library
Controller Card, Drive 1 Shoe Assembly, Drive Divider and any expansion cards must be removed to
remove the Card Cage/Back Plane assembly.

Card Cage/Back Plane Removal

1) If the library is operational, remove any cartridges in the drives using the Graphical User
Interface (GUI) or application software.
2) Exit the application software and halt the operating system if necessary.
3) Power off the library using the GUI and then switch the Master Power Switch on the power
supply at the rear of the module to the off (0) position. Remove the power cord.
4) Remove the Library Controller Card using
and any Virtual Interface Archtecture cards using
Replace" instructions in this chapter.
5) Remove the Drive 1 Shoe Assembly using
instructions in this chapter.
6) Remove the Tabletop Cover, Front Main Cover and Fan Cover Assembly using
Covers Remove and Replace"
7) Remove the screw from the inside Card Cage/Back Plane Connector Access Plate and lift it
out of the library
8) Remove the 2 screws from the outside Card Cage/Back Plane Connector Access Plate remove
it from the library.
9) Remove the Upper Drive divider using
this chapter.
10) Remove the cable access panel (2 screws) from the side of the unit.
11) From inside the drive bay, remove two flat-head screws at the top of the Card Cage and one at
the bottom rear of the Card Cage.
"Library Controller Card Remove and Replace"
"Drive Shoe Assembly Remove and Replace"
using instructions in this chapter.
(Figure 3–39).
"Drive Divider Remove and Replace"
C C /B P R
ARD AGE ACK LANE EMOVE AND
"Fibre Channel Option Card Remove and
Servicing the Neo Series 4000
R
EPLACE
"Library
instructions in
3-51
t