Overland Storage Neo Series Library Service Manual page 231

Table 4-3 View SCSI Options (Continued)
Option
Test Unit Ready Reporting Lets you specify the response to a TEST UNIT READY command
if the library is in Sequential Mode. The possible settings are
Check Condition-Not Ready or Good Status. The default is
Check Condition - Not Ready.
Device Capability Page Lets you choose between two lengths of the Mode
Length Sense/Select device capabilities page (SCSI page 1Fh), which
are short (14 bytes) and long (18 bytes), to accommodate
different SCSI device implementations of this page. The default
is Short (14 bytes).
Transport Element Base Lets you set the base address for the robotics mechanism. The
Address default is 0.
Storage Element Base Lets you set the base address for the magazine slots. The
Address default is 20.
Transfer Element Base Lets you set the base address for the tape drives. The default
Address is 1e0.
Import/Export Element Base Lets you set the base address for the mail slots. The default is
Address 1c0.
Product Identification Lets you specify the response of the library's robotics to the
SCSI INQUIRY command in the Product ID fields. The default is
"NEO Series."
Vendor Identification Lets you specify the response of the library's robotics to the
SCSI INQUIRY command in the Vendor ID field. The default is
"Overland".
Post Recovered Errors The default is "Disabled"
TapeAlert Mode Specifies conditions for logging and reporting Tape Alert data.
The default is Logging Disabled.
Abort Move Status Lets you specify the SCSI response while aborting a SCSI
command. The possible settings are Busy or Not Ready. The
default is Busy.
Door Open Response Lets you specify the SCSI response when a library door is
open. The settings are Ready or Not Ready. The default is Not
Ready.
Initiate Wide Data Transfer Lets you enable the library to initiate a SCSI synchronous and
Negotiation wide data transfer negotiation with the host. The settings are
Do Not Initiate or Initiate. The default is Initiate.
Data Transfer Speed Lets you set the SCSI data transfer rate to Synchronous, 10
MB/sec, 5 MB/sec or Asynchronous Only. The default is
Synchronous, 10 MB/s.
M
Description
S
ENU ELECTIONS
Operation 4-19
t