Overland Storage Neo Series Library Service Manual page 249

Table 5-2 Fault Symptom Codes (Continued)
Message
Drive Status Fail
Command response from unexpected
source
Control command execution failed
Control response not matched to a known
command
Loader response not matched to a known
command
Drive response not matched to a known
command
Flash response not matched to a known
command
Drive index on Update Status message
was invalid
The Drive response was not expected
The opcode for a WORD message was
unknown
The opcode for a DWORD message was
unknown
The button causing library to go offline
was unknown
Destination Xchg was Null
Sending of a cmd failed
Deactivating a drisve that is not attached
FSC ERP
503D F The cleaning operation failed because the
librray could not retrieve drive status.
7001 D,G A command response was received from
a task to which a command had not been
sent.
7002 D,G A command response opcode from the
Control task was was not anticipated or is
un-identifiable.
7003 D,G A command response was received from
the Control task, but the original
command opcode could not be
determined.
7004 D,G A command response was received from
the Loader task, but the original command
opcode could not be determined.
7005 D,G A command response was received from
a Drive task, but the original command
opcode could not be determined.
7006 D,G A command response was received from
the Flash task, but the original command
opcode could not be determined.
7007 C,D,G An Update Drive Status message was
received from a module, but the drive
index was out of range.
7008 C,D,G A command response was received from
a Drive task to which a command had not
been sent.
7009 C,D,G A WORD-sized message was received but
the message opcode could not be
identified.
700A C,D,G A DWORD-sized message was received
but the message opcode could not be
identified.
700B C,D,G A command to take the library offline was
completed successfully, but the GUI
button that initiated the action could not
be identified.
700C C,G Attempting to send a command to a task,
but the argument exchange pointer was
NULL.
700D C,G An attempt to place a command on a task
exchange failed.
700E C,G The Control task is indicating that a
request to deactivate a drive failed becase
the drive is not attached.
F S C (FSC )
AULT YMPTOM ODES S
Troubleshooting 5-9
t