Configuring The Router Manually - Talkswitch Voip Network Configuration Manual

Configuring the router manually

If you cannot access the router configuration through the IP Configuration page, configure the
router manually.
1. Open the router configuration and navigate to the screen used to set up port forwarding. See
your router documentation.
2. In the Management software on the IP Configuration page, click the Manual Port Mapping
Required link.
3. Map the port indicated for SIP (VoIP) signaling.
If required, you can map a different port. Select Troubleshooting > VoIP and enter the port in
the SIP signalling port field.
Map the rest of the ports to the IP addresses indicated in the Manual Port Mapping window.
If required, you can map different ports. Select Troubleshooting > VoIP.
4. Map ports 9393, 8485 and 8486 (Type: TCP) to the unit acting as local proxy to allow remote
configuration of the system.
5. If available, enable Quality of Service (QoS) to give voice traffic priority over data.
6. Save the configuration to the router.
8 T A L K S W I T C H V O I P N E T W O R K C O N F I G U R A T I O N G U I D E