Configuring Hosts For Encryption Targets - Brocade Communications Systems Brocade 8/12c User Manual

18

Configuring hosts for encryption targets

Configuring hosts for encryption targets
Use the Encryption Target Hosts dialog box to edit (add or remove) hosts for an encrypted target.
NOTE
Hosts are normally selected as part of the Configure Switch Encryption wizard, but you can also edit
hosts later using the Encryption Target Hosts dialog box.
1. Select Configure > Encryption from the menu task bar.
2. Select a group, switch, or engine from the Encryption Center Devices table that contains the
FIGURE 231
3. Select a target storage device from the list, then click Hosts.
520
The Encryption Center dialog box displays
storage device to be configured, then select Group/Switch/Engine > Targets from the menu
task bar, or right-click a group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays
Encryption Targets dialog box
The Encryption Target Hosts dialog box displays
hosts in a fabric.
(Figure 153).
(Figure 231).
(Figure 232). The dialog box lists configured
Brocade Network Advisor SAN User Manual
53-1002167-01