Configuring hosts for encryption targets
Use the Encryption Target Hosts dialog box to edit (add or remove) hosts for an encrypted target.
NOTE
Hosts are normally selected as part of the Configure Storage Encryption wizard but you can also edit
hosts later using the Encryption Target Hosts dialog box.
1. Select Configure > Encryption from the menu bar.
2. Select the encryption group, switch, or encryption engine containing the storage device to be
3. Select Targets.
4. Select a Target storage device from the list, and click Hosts.
5. Select one or more hosts in a fabric and move them to the Selected Hosts table.
FIGURE 244
DCFM Enterprise User Manual
53-1001775-01
The Encryption Center dialog box displays.
configured.Right-click, or select Group, Switch, or Engine from the menu bar.
The Encryption Targets dialog box displays.
The Encryption Target Hosts dialog box displays. This dialog box lists configured hosts in a
fabric.
Encryption Target Hosts dialog box
Configuring hosts for encryption targets
20
551