Adding An Lldp Profile - Brocade Communications Systems Brocade 8/12c User Manual

5. Select the Global Configuration LLDP profile in the LLDP Profiles table.
6. Click the left arrow button to edit.
7.
8. When you have finished the configuration, click OK to launch the Deploy to Products dialog

Adding an LLDP profile

NOTE
When a TE port is selected to assign to an LLDP profile, a yellow banner displays with the following
error message: "LLDP-DCBX is disabled on this switch. The configuration becomes functional when
LLDP-DCBX is enabled on the switch."
1. Select Configure > DCB from the menu bar.
2. Select a switch, and click Edit.
3. Click the LLDP-DCBX tab on the Edit Switch dialog box.
4. Click the Enable LLDP-DCBX checkbox.
Brocade Network Advisor SAN User Manual
53-1002167-01
FIGURE 131
Edit Switch dialog box - LLDP-DCBX tab
Select the FCoE Application and FCoE Logical Link check boxes in the Advertise table to
advertise them on the network.
box, shown in Figure 134.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
The LLDP-DCBX dialog box displays.
LLDP-DCBX configuration
14
367