Adding An Lldp Profile - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

Adding an LLDP profile

The LLDP profile determines LLDP settings per port.
To add an LLDP profile, perform the following steps.
1. Select the DCB tab on the Switch Administration window.
2. Select the LLDP-DCBX tab.
3. Select the LLDP Profile tab.
4. Click Add.
5. Enter a name for the configuration in the Name field.
6. Optionally, add a description in the Description field.
7.
8. In the Hello field, enter a time value in seconds.
9. In the Multiplier field, set the number of consecutive misses allowed before LLDP considers
10. Select the parameters you want to exchange.
Web Tools Administrator's Guide
53-1002756-01
The LLDP Configuration dialog box displays.
Select the Mode.
For Mode, the choices are Tx (transmit), Rx, (receive) or Both. The default is Both.
The Hello value sets the interval between hello bridge protocol data units sent by the root
switch configuration messages. The range is 4 to 180 seconds. The default is the global
configuration range.
the interface to be down.
The range is 2 to 10. The default is the global configuration range. The multiplier is related to
the Hello time interval. Using the defaults, you wait four times (the multiplier value) at 30
second intervals (the hello value) before giving up on the interface.
Note that the term TLV indicates packaging of parameters into a Brocade-specific
Type/Length/Value (TLV).
-
Advertise Optional-tlv—Advertises the following optional TLVs:
•
system-description—Describes switch or blade characteristics.
•
port-description—Describes the configured port.
•
system-name—Specifies the system name.
•
system capabilities—Describes the system capabilities.
LLDP-DCBX configuration
17
219