Invoking Failback; Adding Encryption Targets - Brocade Communications Systems Brocade 8/12c Administrator's Manual

Invoking failback

To invoke failback to the restarted encryption engine from the Management application, complete
the following steps.
1. Select Configure > Encryption from the menu task bar.
2. Select an encryption group from the Encryption Center Devices table to which the encryption
3. Select the online encryption engine, then click Failback.
4. Click OK.
5. Click Close on the Encryption Center dialog box.

Adding encryption targets

Adding an encryption target maps storage devices and hosts to virtual targets and virtual initiators
within the encryption switch.
NOTE
It is recommended that you configure the host and target in the same zone before configuring them
for encryption. If the host and target are not already in the same zone, you can still configure them
for encryption, but you will need to configure them in the same zone before you can commit the
changes. If you attempt to close the Encryption Targets dialog box without committing the changes,
you are reminded of uncommitted changes in the Management application.
1. Select Configure > Encryption from the menu task bar.
2. Select a group, switch, or engine from the Encryption Center Devices table to which to add the
Fabric OS Encryption Administrator's Guide
53-1002159-03
The Encryption Center dialog box displays.
engine belongs, then click Group > HA Clusters, or right-click the group and select HA Clusters.
The Encryption Group Properties dialog box displays, with the HA Clusters tab selected.
The Encryption Center dialog box displays.
target, then select Group/Switch/Engine > Targets from the menu task bar, or right-click a
group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays.

Adding encryption targets

2
57