Thconfig Command; Table 11 End-To-End Performance Monitor Class Default Settings - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

6

thConfig command

Table 11
TABLE 11
Area
End-to-end receive
performance
(RX performance)
End-to-end transmit
performance
(TX performance)

thConfig command

You can use the thConfig command to customize event monitoring thresholds for the Fabric,
Security, SFP, and Performance classes or to display the configuration. It is recommended,
however, that you use the default settings for these classes.
If configured areas exceed the currently-effective threshold settings, the Fabric Watch daemon can
take one of the following actions:
•
•
•
For complete information about using the thConfig command, refer to the Fabric OS Command
Reference Manual.
46
provides default settings for areas in the End-to-End Performance Monitor class.
End-to-End Performance Monitor class default settings
Description
Monitors the
receiving traffic
between a SID_DID
pair in a port
Monitors the transmit
traffic between a
SID_DID pair in a port
Send an SNMP alarm.
Log a RASlog message.
Send an e-mail alert.
Default threshold settings Default alarm
settings
Unit: KBps Below: 0
Time Base: none Above: 0
Low: 0
High: 0
Buffer: 0
Unit: KBps Below: 0
Time Base: none Above: 0
Low: 0
High: 0
Buffer: 0
Threshold state
Informative
Informative
Informative
Informative
Fabric Watch Administrator's Guide
53-1002752-01