Checking The Operation - Canon ImageRunner 600 Service Manual

Hide thumbs Also See for ImageRunner 600:

Table of Contents

CHAPTER 11 INSTALLATION

Checking the Operation

1) If the Communications Control Board-A1

or the Interface Board-B1 is not to be con-

nected (not requiring the Power Supply-

A1), go to step 4).

Connect the connector [1] of the power

supply to the connector [2] of the control-

ler securely as shown.

Check to make sure that the cord is in the

groove of the board.

2) Connect the power supply to the power

plug, and check to make sure that LED1

of the controller turns on.

Groove of the board

Figure 11-C601

Figure 11-C602

CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.

Table of Contents