Relocating The Copier - Canon ImageRunner 600 Service Manual

Hide thumbs Also See for ImageRunner 600:

Table of Contents

RELOCATING THE COPIER

If the copier must be relocated by truck or other means of transportation, perform the follow-

Make a copy in Direct.

Remove all paper from all

Turn off the power switch, and

disconnect the power plug from the

Fix the No. 2 mirror mount in place

with the locking plate working

through the left cover side.

Remove the developing assembly.

Tape the transfer charging

assembly, fixing/feeding unit

releasing lever, and lower feeding

assembly in place.

Tape the front door, hopper cover,

each cassette, and main right door

(upper/lower) in place.

Place A3 copy paper on the

copyboard glass, and tape the ADF

A. Keep the following in mind when using stairs to deliver the copier in or out of the user's:

1. Remove the fixing/feeding unit, holding tray, and copy paper from the copier, and

transport them separately from the copier.

(If the ADF is installed, be sure to remove it also.)

2. When holding the copier, do not use the hand grips of the pickup assembly/delivery

assembly; instead, support it by grasping the four corners of its bottom.

B. Shift up the two adjusters (front) on the copier's bottom to make sure that they are un-

locked. Further, take care so that the adjusters will not slip off the copier during transpor-

C. When delivering the copier into/out of the user's, be sure to remove the accessories (side

paper deck, finisher).

CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.

Check to make sure that the

No. 2 mirror mount will not

Transport the developing

assembly separately.

CHAPTER 11 INSTALLATION

Table of Contents