Canon ImageRunner 600 Service Manual page 804

CHAPTER 13 TROUBLESHOOTING
<FEEDER>
Level 3
DOCST- Adjusting the Original Stop Position for Pickup for the
M Feeder (manual tray pickup)
Operation
1) Select DOCST-M.
2) Place paper on the manual feed tray (A3/11"×17").
3) Enter a setting using the keypad.
4) Press the OK key.
• The paper on the manual feed tray will be picked up
and stopped on the copyboard glass.
5) Open the feeder slowly, and check the position of
6) Close the feeder slowly without removing the paper.
7) Press the OK key.
• The paper on the copyboard board glass will be
delivered to the manual feed tray.
8) If the stop position is not as indicated, go back to
13-216
COPYRIGHT © 1999 CANON INC.
Description
Original stop position
Higher setting Lower setting
Original
Standard:
11 ±1 mm
the paper.
step 3), and make adjustments once gain.
Range : -50 to 50 (Each '1'
causes a shift of 0.5 mm)
• The data is retained by
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
FEEDER>ADJUST
Remarks
the ADF controller PCB
on the feeder side.