Canon ImageRunner 600 Service Manual page 501

Hide thumbs Also See for ImageRunner 600:

Table of Contents

Turn over the slope plates, and match the

pin holes of the skid and the pin holes of

the slope plates; then, fit the pins (one

Holding the grips (front, rear) of the

copier, slide the copier down the slope

plates off the skid.

The pins are taped in place to the

Open the cardboard box that comes with

the copier, and take out the parts and sub

members. Check that none of the

attachments is missing.

Put away the grip used in step 4) in the

compartment behind the front cover.

Mount the face covers (right and left) that

have been removed.

Before moving on to the next steps, check to see if there is condensation on the outside or the

inside of the copier right after taking it out of its shipping box. If condensation is found, stop

the work and wait until the copier has become used to the room temperature.

Start the steps that follow after making sure that the copier is free of condensation.

CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.

CHAPTER 11 INSTALLATION

Slope plates

Chapters

Table of Contents