Routing The Charging Wire - Canon ImageRunner 600 Service Manual

Hide thumbs Also See for ImageRunner 600:

Table of Contents

CHAPTER 6 IMAGE FORMATION SYSTEM

5) Take out the felt holder [1] through the

cut-offs in the shielding plate [5].

6) Pick the wire cleaner with radio pliers, re-

lease the hook with your fingers. (See Fig-

ure 6-C702.)

Routing the Charging Wire

As a rule, the charging wire (except the

grid wire) is routed in the same way for all

charging assemblies; the following uses the

charging assembly:

1) Remove the screw one each [1], and de-

tach the shielding plates (left/right) [2].

To prevent deformation (slack) of the pri-

mary charging assembly, be sure to work

on the left and right shielding plates sepa-

rately. (Do not loosen the screws on both

left and right shielding plates.)

2) Remove the wire cleaner.

For other charging assemblies, remove

the lids (2 pcs.).

3) Free a length of about 5cm from the

charging wire reel (wire diameter 0.06

mm), and form a loop on the end (2mm in

When forming a loop, wind the wire

around the hex key once, and twist the

hex key three to four times; then, twist

the charging wire to form a loop easily.

Figure 6-C706

Figure 6-C707

Figure 6-C708

CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.

Charging electrode

Table of Contents