Canon ImageRunner 600 Service Manual page 524

Hide thumbs Also See for ImageRunner 600:

Table of Contents

CHAPTER 11 INSTALLATION

8) If IC6 [11] is mounted on the PCB of the

controller, shift SW2-7 of the DIP switch

[12] to ON; otherwise, shift the bit to

Note 1: If the IC6 [11] is not mounted, you

need not mount one.

Note 2: If the ROM (IC6) [15] is mounted or if

you are replacing it, be sure to shift

SW2-7 of the DIP switch [12] to ON.

9) Set the bits of the DIP switch (SW3) [13]

on the PCB of the controller as shown in

Table 11-501.

Keep it to OFF at all times.

Sets the line to push pulse.

Sets the line to dial pulse.

Sets the dial pulse speed to 20PPS.

Sets the dial pulse speed to 10PPS.

Table 11-501

LED1 LED2 LED3

Figure 11-508

LED1 LED2 LED3

Figure 11-509

Set the modem signal transmission level to -16 dBm.

Set the modem signal transmission level to -14 dBm.

Set the modem signal transmission level to -12 dBm.

Set the modem signal transmission level to -10 dBm.

CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.

Chapters

Table of Contents