Canon ImageRunner 600 Service Manual page 841

Code
• The BD PCB is faulty.
E100
• The image processor PCB is faulty.
• The DC controller PCB is faulty.
• The laser unit is faulty.
• The laser driver PCB 1 is faulty.
• The laser driver PCB 2 is faulty.
• The wiring is faulty (short circuit, open
circuit).
• The image processor PCB is faulty.
• The laser driver PCB 1 is faulty.
E102
• The wiring is faulty (short circuit, open
circuit).
• The laser scanner motor (M4) is faulty.
• The laser scanner driver is faulty.
E110
• The DC controller PCB is faulty.
• The wiring is faulty (short circuit, open
circuit).
• The laser scanner motor (M4) is faulty.
• The DC controller PCB is faulty
E111
• The wiring is faulty (short circuit, open
circuit).
• The laser driver cooling fan (FM5) is
faulty.
• The DC controller PCB is faulty.
E121
• The wiring is faulty (short circuit, open
circuit).
• The scanner motor (M5) is faulty.
(E202)
• The scanner home position sensor (PS1)
No code. Keys
is faulty.
disabled.
(Note 2)
• The DC controller PCB is faulty.
• The scanner motor (M5) is faulty.
• The image leading edge sensor (PS3) is
(E204)
faulty.
No code. Keys
• The DC controller PCB is faulty.
disabled.
(Note 2)
• The fluorescent lamp heater inside
thermistor is faulty.
• The light intensity control PCB is faulty.
E211
• The DC controller PCB is faulty.
• The wiring is faulty (short circuit, open
circuit).
• The fluorescent lamp heater inside
thermistor is faulty.
• The light intensity control PCB is faulty.
E215
• The DC controller PCB is faulty.
• The wiring is faulty (short circuit, open
circuit).
COPYRIGHT © 1999 CANON INC.
Cause
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 13 TROUBLESHOOTING
Description
• The BD signal does not arrive within 1
sec after the output of the laser drive
signal.
• The BD signal does not arrive for 1 sec
or more while the laser is on.
• The laser power data cannot be written
to the laser driver PCB 1 when starting
copying or printing operation.
• The constant speed rotation signal (LM-
RDY) does not arrive for 15 sec or more
after the output of the laser scanner
motor (M4) drive signal.
• The lock signal (FM14LCK) is detected
for 5 sec or more while the laser scanner
fan (FM14) is being driven.
• The lock signal (FM5LCK) is detected
for 5 sec or more while the laser driver
cooling fan (FM5) is being driven.
• The scanner home position is not
detected within a specific period of time
when the power switch or the Copy Start
key is pressed.
• No image signal is detected while the
scanner is moving forward in fixed
reading mode or when the home position
is being detected.
• No image signal arrives from the ADF
while in stream reading mode.
• The temperature around the fluorescent
lamp does not exceed 10°C 2 sec after
the fluorescent lamp heater has turned on
at power-on.
• The temperature around the fluorescent
lamp is 0°C or less at power-on.
• The temperature around the fluorescent
amp is 170°C or more when the
fluorescent lamp is off.
13-253