Canon ImageRunner 600 Service Manual page 483

4) Remove the front cover of the deck. (See
p. 10-21.)
5) Remove the four screws [3], and detach
the roll support plate [4].
6) Remove the coupling shaft [5] and the E-
ring [6]; then, detach the pulley cover [7].
7) Remove the two screws [8], and detach
the cable fixing plate [9] on the left side;
then, detach the lifter cable [10] on the
outside.
8) Remove the two screws [11], and detach
the cable fixing plate [12] on the right
side; then, detach the lifter cable [13] on
the inside.
9) To detach the lifter cable [13] on the in-
side from the pulley [14] on the inside, re-
move the two set screws [16] on the pulley
[15] on the outside, and detach the pulley
[15] on the outside.
COPYRIGHT © 1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 10 SIDE PAPER DECK
[4]
Figure 10-C308
[16] [10] [13]
[8] [9] [14][15]
Figure 10-C309
[3]
[12][11]
[7]
[6]
[5]
10-35