CHAPTER 7 PICK-UP/FEEDING SYSTEM
9.
Removing the Duplexing Reversal
Sensor
1) Remove the duplexing unit from the
copier.
2) Remove the front cover.
3) Remove the motor support plate.
4) Remove the following from the front side
of the reversing roller shaft [1]:
• E-ring [2]
• Gear [3] and parallel pin [4]
• E-ring [5]
• Spacer [6]
• Bearing [7]
5) Remove the following from the rear of the
reversing roller shaft [1]:
• E-ring [8]
• Spacer [9]
• Bearing [10]
7-82
COPYRIGHT © 1999 CANON INC.
[1] [2][3] [4]
Figure 7-F812
[1]
[8]
Figure 7-F813
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
[6] [7]
[5]
[9]
[10]