Mounting The Blade; Removing The Developing Cylinder - Canon ImageRunner 600 Service Manual

CHAPTER 6 IMAGE FORMATION SYSTEM
4.

Mounting the Blade

Mount the blade by reversing the steps
used to remove it.
1) Butt the blade mounting plate against the
developing assembly, and secure it in
place with five screws.
Be sure to put copy paper over the devel-
oping cylinder for protection before start-
ing to mount the blade.
2) Mount the polarity plate with a screw.
5. Removing the Developing
Cylinder
1) Remove the developing assembly from
the copier.
2) Remove the blade unit.
3) Remove the three mounting screws [1]
from the rear, and detach the deceleration
gear retainer [2].
4) Remove the three gears [3].
6-72
COPYRIGHT © 1999 CANON INC.
[1]
Figure 6-E707
[3]
Figure 6-E708
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
[2]
[1]