Canon ImageRunner 600 Service Manual page 797

<DEVELOP>
Adjusting the Developing Bias Output
Level 3
DE-DC Use it to enter a DC bias output value for the image
area.
DE-NO- Use it to enter a developing bias output value for
DC sheet-to-sheet distance.
DE- Use it to adjust the offset value of the developing DC
OFST bias.
<DENS>
Fine-Adjusting Copy Density Auto Correction
Level 3
DENS- Correcting Copy Density
ADJ • Use it to correct the f-value table if the copy image is
foggy or the high-density area is blurred.
COPYRIGHT © 1999 CANON INC.
Description
Lighter image
Lower value
Description
White
F9 F1
Black
Original density
A lower setting
decreases fogging.
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 13 TROUBLESHOOTING
Higher value
Darker image
White
A higher setting
decreases blurring.
COPIER>ADJUST
Remarks
Range: 0 to 500
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.
Range : -50 to 50
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.
Remarks
Range : 0 to 9 (default at 3)
13-211