Canon ImageRunner 600 Service Manual page 525

Hide thumbs Also See for ImageRunner 600:

Table of Contents

10) Connect the power supply unit to the

power plug, and check to make sure that

LED1 [14] (green) on the PCB of the con-

troller turns on.

11) Execute RAM clear. Set the bits of the

DIP switch [15] (SW2) on the PCB of the

controller as shown in the following table,

and push the push switch [16] (SW4) so

that LED5 [17] (red) turns on.

See step 8).

CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.

CHAPTER 11 INSTALLATION

LED1 LED2 LED3

Figure 11-510

LED1 LED2 LED3

Figure 11-511

Chapters

Table of Contents