Canon ImageRunner 600 Service Manual page 798

CHAPTER 13 TROUBLESHOOTING
<BLANK>
Adjusting the Non-Image Width
Level 3
BLANK- Use it to enter a non-image width adjustment value for
T the image leading edge.
BLANK- Use it to enter a non-image width adjustment value for
B the image trailing edge.
<V-CONT>
Adjusting the Potential Control System
Level 3
EPOTOFST Use it to enter an offset value for the potential sensor.
VL- Use it to enter an offset value for the VL target
OFST potential.
VD- Use it to enter an offset value for the VD target
OFST potential.
13-212
COPYRIGHT © 1999 CANON INC.
Description
Description
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
COPIER>ADJUST
Remarks
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.
Remarks
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.